|
| |
BACK
GO
TO BURKS
WATER SYSTEMS
 |
BURKS
HIGH CAPACITY CENTRIFUGALS
|
FOR MORE INFORMATION E-MAIL US, OR
FOR A DISCOUNTED QUOTE,
FILL OUT OUR INFO FORM
BURKS 10-500
GPM,
1-1/4" TO 2-1/2" PORTS IN BRONZE & CI
| The Burks G series
centrifugal comes standard in bronze fitted cast iron. They are also
available in bronze. Sizes range from 1-1/4" to 2-1/2" ports
requiring 1/3 to 25 horsepower. Flows range from
10 to 520GPM and heads from 5 to 360 feet. These
pumps are available with a variety of motor specs and enclosures including
single and three phase, 50 & 60 hz, IEEE-45, and custom configurations
to meet MSA, Lloyds, ABS, and USCG specifications.
Below are a few of the pump & motor
combinations available. Call us for information on the configuration
to meet your requirements. |
 |
UP TO 100 TDH, 90
GPM
UP TO 190 TDH,
510 GPM
UP TO 360 TDH,
535 GPM
100-1, 875GPM,
3" TO 6" PORTS IN CAST IRON
 |
The Burks self-priming WB
series comes in 3", 4", and 6" ports and are constructed
of sturdy class 30 cast iron. These pumps will pass solids up to 1/4
of its port size, pump up to 1,875 gpm, and reach up to a head of 184
feet. Suction and discharge ports are standard
ANSI flanges with drilled and tapped fittings
for the installation of vacuum and pressure gauges. Each pump contains
a hinged check valve, grease lubricated mechanical
seal, lubricated double ball bearings, and
replaceable volute and wear plate. These pumps come in a pedestal
configuration suitable for direct or pulley drive. Below is general
information on the pumps themselves. Please call for
motor selection assistance. |
BACK
BURKS WATER SYSTEMS |
