STOWAWAY 5 CRUSAIR SELF-CONTAINED
AIR CONDITIONER UNIT
FILL
OUT THE
INFO
FORM AND WE WILL QUOTE
YOU
THE BEST POSSIBLE PRICE
SELF-CONTAINED |
|
StowAway 5 is a series of self- contained,
direct expansion, sea- water-cooled, reverse-cycle air conditioners designed for marine
use. There are two basic product groups in the StowAway 5 series.
|
| |
|
DLKPKMV; |
|
SX models are used with the SMX II
microprocessor control and includes the SMX II power/logic models. SH models are designed
for use with rotary-type or SMX controls.
The low-profile self-contained unit is designed to be installed under a settee or berth,
in a locker or cabinet, or any other out-of-the-way location, with air ducted to a
discharge-air grill which is normally placed high in the cabin. A return-air grill is
situated low near the StowAway unit. |
|
The StowAway unit contains all
air conditioning components, including the refrigerant compressor, condenser, evaporator,
blower, receiver and accumulator, lint screen, wiring and other associated components,
mounted on a low-profile chassis. Hold-down clamps and the condenser drain fitting are
also included. The condenser drip pan is designed so that it encloses the entire drip line
of the unit. The dependable reciprocating compressors are refrigerant cooled to provide
maximum efficiency and life. Cruisair has designed the StowAway series with increased
tubing size and limited restrictive elbows and bends in the refrigerant circuit, in
conjunction with accumulators and receivers, providing improved compression ratios in both
the cooling and heating modes. The highly efficient condenser contains rifled/spiral
heat exchangers with very little pressure drop. The evaporator coil contains rifled tubing
and lanced tins to increase heat exchange. The quiet, efficient squirrel-cage
blowers can be rotated for discharge in any direction. The design and location of the
transition ring minimizes restriction and allows full use of the coil.
|
 |
The StowAway unit is designed for easy
installation and serviceability. All wiring hookups, starting components and charging
ports are conveniently located on top of the unit. The units are pre-charged and tested at
the factory, eliminating the need to field charge. In addition to the basic StowAway unit,
the following components are required to complete the installation and are ordered
separately: Seawater Cooling System, Air Distribution System, and Controls. |
|
|
Features |
StowAway
5
- 7,000 - 24,000 BTU
- 115V & 230V, 60 & 50 Hz models
- Reverse-cycle for heating & cooling
- Low profile unit
- Routable blower for discharge in any direction
- Convenient pre-wired plug
SX Models
- For use with SMX II controls
- Pre-installed temperature sensors
- High & Low refrigerant pressure switches
SH Models
- For use with SSA or SMX controls
- Accessible terminal strip for wiring hookup
- Separate power/logic module when used with SMX
|
|
